<aside> 🔥
Please be careful whether the items are complete and intact. All pictures in this manual are for reference only. If they do not match the actual items, please refer to the actual ones.
</aside>
Step 1: Connect Type - C cable
Insert the Type - C connector into the depth camera interface first and then pass through the depth camera support.
Please insert the Type - C connection cable before proceeding to the next step. If the cable needs to be pulled out after installation, the fastening screw needs to be removed first, and do not forcefully pull to avoid damaging the cable!
Step 2: Install fixing plate 1
Use two M3 screws to secure the fixing plate 1 and support to the hole position on the back of the depth camera and then tighten it.
Step 3: Install fixing plate 2
Use two fastening screws to pass through the hole position of fixing plate 1, the gasket, and fixing plate 2 in sequence, and then tighten them.
There are four gears available for the fixed plate 1 hole position, which can adjust the camera height and angle range. Users can choose different gear heights and angles according to their needs, as shown in the following figure:
Step 4: Fixed depth camera to dog head
Remove the screw from the fixed hole of the head depth camera, used for fixing.
Place the fixed base on the Go2 head, aligning it with the head installation hole, use the removed screw to fix the depth camera to the GO2 head, and then tighten it.