The information in this manual does not include the design, installation and operation of a complete robot application, nor does it include all peripheral equipment that may affect the safety of the complete system. The design and use of the complete system need to comply with the safety requirements established in the standards and regulations of the country where the robot is installed. HUNTER SE integrators and end customers have the responsibility to ensure compliance with the applicable laws and regulations of relevant countries, and to ensure that there are no major dangers in the complete robot application. This includes but is not limited to the following:

Table of Contents

Effectiveness and responsibility

• Make a risk assessment of the complete robot system.
• Connect the additional safety equipment of other machinery defined by the risk assessment together.
• Confirm that the design and installation of the entire robot system's peripheral equipment, including software and hardware systems, are correct.
• This robot does not have the relevant safety functions of a complete autonomous mobile robot, including but not limited to automatic anti-collision, anti-falling, creature approach warning, etc. Relevant functions require integrators and end customers to conduct safety assessment in accordance with relevant provisions and applicable laws and regulations to ensure that the developed robot is free of any major hazards and hidden dangers in practical application.
• Collect all the documents in the technical file: including risk assessment and this manual.

Environmental

• For the first use, please read this manual carefully to understand the basic operating content and operating specification.
• It is strictly forbidden to carry people
• For remote control operation, select a relatively open area to use HUNTER SE, because it is not equipped with any automatic obstacle avoidance sensor. Please keep a safe distance of more than 2 meters when HUNTER SE is moving.
• Use HUNTER SE under -10°C~ 45°C ambient temperature.
• The waterproof and dust-proof capability of HUNTERSE is IP22.

Pre-work Checklist

• Make sure each equipment has sufficient power.
• Make sure the vehicle does not have any obvious defects.
• Check if the remote controller battery has sufficient power.
• When using, make sure the emergency stop switch has been released.

Operation

• Make sure the area around is relatively spacious in use.