<aside> š„
Please fix the charging board according to the indicated direction and do not install it in the opposite direction ļ¼ļ¼!
</aside>
Step 1: Install the nameplate by fixing the nameplate board to the nameplate support using the knurled hand screws.
Step 2: Install the charging board by fixing it to the nameplate support.
Step 1:Ā Pre-charging check:Ā Before each charging, please check if there are any foreign objects obstructing the charging electrodes on the bottom of the Go2 body, as well as any obstructions on the surface of the charging boardās charging electrodes. Use a dry cloth to wipe the surface of the charging electrodes to ensure good contact during the charging process.
Step 2:Ā Connect the power:Ā Place the Go2 charging station in an open indoor area, first plug the fast-charging charger into the AC power supply and then connect the power interface on the bottom of the charging board. Secure the cable in the cable slot of the charging board as shown in the diagram.
Step 3:Ā Charging:Ā When using the charging station to charge, first place the Go2 in a prone position, aligning the head with the orientation of the nameplate on the charging station. This allows the two charging electrodes on the bottom of the Go2 to make contact with the two charging electrodes on the charging board to initiate charging. When the battery is fully charged, the charging station will automatically disconnect from the battery.
<aside> š„
Note: The charging station has polarity, please align the head in the direction of the nameplate during charging and do not reverse it! If charging abnormalities occur, please check if the charging electrodes are in good contact.
</aside>
Use the Go2 charging pad with the corresponding return charge marking board to achieve the automatic return charge function based on Go2's built-in L1.