Check

• Check the condition of the vehicle body. Check if the vehicle body has obvious abnormalities; if so, please contact after-sales support.
• When using for the first time, confirm whether Q2 (power switch) in the rear electrical panel is pressed; if it is not pressed, please press it and release it, then it is in the released state.

Table of Contents

Startup

• Press the power switch (Q2 in the electrical panel); under normal circumstances, the light of the power switch will light up, and the voltmeter will display the battery voltage normally.
• Check the battery voltage. If the voltage is greater than 48V, it means the battery voltage is normal. If the voltage is lower than 48V, please charge; when the voltage is lower than 46V, BUNKERPRO cannot move normally.

Shutdown

• Press the power switch to cut off the power.

Basic operating procedures of remote control

• After starting the BUNKERPRO robot chassis normally, start the remote control and select the remote-control mode to control the movement of the BUNKER PRO platform through the remote control.

Charging

BUNKERPRO is equipped with a standard charger by default, which can meet the changing needs of customers. The specific operating procedures of charging are as follows:

• Make sure that the BUNKERPRO chassis is in a shutdown state. Before charging, please make sure that Q2 (power switch) in the rear electrical console is turned off; insert the plug of the charger into the Q3 charging interface in the rear electrical control panel.
• Connect the charger to the power supply and turn on the charger switch to enter the charging state.
• When charging by default, there is no indicator light on the chassis. Whether it is charging or not depends on the status indicator of the charger.

Home Page: Bunker Pro

Next Page: Development